| 1. | Foundation of relation curve and realization of computer microsoft based on regression
基于回归的关系曲线建立及计算机软件实现 |
| 2. | The application of least squares chaos algorithm for stage - discharge relation curve fitting
最小二乘混沌算法在水位流量关系拟合中的应用 |
| 3. | At all test potelltials , but not affected l - v relations curve . using perforated whole cell patch cl
在穿孔模式下， 100umsnp可以明显抑制ib 。 |
| 4. | The experimental results which give the relation curve between the sensor output signal and the temperature variation confirm that this method is effective
通过实验，给出了传感器输出信号与温度变化的关系曲线，实验结果表明了该测量方法的可行性。 |
| 5. | Vibration equation of two - plane balancing rotor is derived . non - linear error of bearing support of hard bearing balancing machine is analysed and relation curve is presented
推导了双面平衡转子的振动方程，分析了硬支承动平衡机的支架非线性误差对振动幅值与相位的影响，并绘制了关系曲线。 |
| 6. | The residual deformation around the hole was measured by digital speckle correlation technique and the relation curves of residual strain at the side of hole vs fatigue life cycles were obtained
再应用数字散斑相关技术测量了不同疲劳循环次数后孔周的残余变形场，并给出了孔边最大残余应变与疲劳循环次数的关系曲线。 |
| 7. | We also performed a nonlinear curve fitting to the intensity relation curve between pumped light and upconversion emission light , and knew that the upconversion luminescence belonged to three - photon absorption
通过对上转换发光强度与泵浦源电流强度关系曲线的拟合，看到这种上转换是三光子吸收过程，这与通过能级图分析得到的结果相同。 |
| 8. | A series of tests on the deformation behaviors of giant magnetostrictive tool rod were done , and the relation curve between the radios of boring cotter and the coil currents was obtained , which validated the controllability and stability of the radios of boring cutter
在此基础上，进行了超磁致伸缩刀杆变形性能试验，获得了镗刀切削半径增量与线圈控制电流之间的关系曲线，验证了超磁致伸缩刀杆的可控性和稳定性。 |
| 9. | Abstract cutter teeth and gear teeth are simplified as mechanical models , the bending deformation at contact nodes is calculated by applying the three - dimension finite element method and analyzing their mechanical condition , the relation curve between shaving force and bending deformation is drawn out
简介：摘要将刀齿和轮齿抽象简化为力学模型，分析其受力状态，并运用三维有限单元法计算各节点的弯曲变形量。 |
| 10. | A mathematical model in the grinding technology of explosion - proof surface is worked out to find out vibration characteristics , amplitude and phase , and educe the relation curve between shape error and technical parameter
进而讨论箱体零件加工工艺过程误差转换模型、形状精度特征、传递图、描述方程、误差转换结构图；提出防爆面磨削工艺系统的数学模型；求解出振动特性、幅值和相位，得出了形状误差与工艺参数的关系曲线。 |
